Answer / sachin k

We can use Phase sequence meter to identify the phase
sequence like R Y B

Is it recommended to apply H.pot test for new cables segments after terminations or joints, however, this cable has been tested before at the manufactor by the vendor ? or only we can apply megger tests ?

1 Answers   Centroid,

---

What OPGW is better than Microwave or PLCC???

0 Answers   Four Seasons,

---

In a star-star connected h.t transformer why we use NGR on the secondary (l.t)side.

3 Answers   Star, TATA,

---

What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?

0 Answers  

---

What is mean CT Saturation? How to calculate?

3 Answers   NetGroup, Tyco,

---

2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping

0 Answers  

---

critically criticize the application of ring main unit in power system

0 Answers  

---

We know that primary transmission is done to reduce current so that i^2*r loss could be minimised but according to ohm's law v is directly proportional to i,which indirectly means higher potential difference means larger current?so how the current is minimised in high power transmission line??

2 Answers  

---

wat s the difference between diode and capacitor

20 Answers   TCS,

---

LT, CC and LMU installed at both the outgoing circuits of 132 kv double ckt transmissio what its means ? and what are there use ?

1 Answers  

---

what is the difference between inrush curent and jurk load.

2 Answers  

---

how generator avr give to the input?

0 Answers  

---