What does the Frame Relay switch use to distinguish between
each PVC connection?
A. data-link connection identifiers (DLCIs)
B. BECNs
C. FECNs
D. the Local Management Interface (LMI)
- 2 Answers
- 8303 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
In IPSec what is SAD, SPD and SA's?
If you are in IOS user mode, which command do you use to enter the privileged mode? A. Set B. Enable C. Configure D. Privileges
What is the command to start IP RIP version 1 routing on a Cisco router? A. show rip B. enable rip C. router enable D. router rip
How many fillers we can put in one ip of ipv6?
Does a bridge divide a network into smaller sections?
Which command line statement determines the number of seconds a dialup connection can wait without any traffic before the router hangs up? A.) dialler max-time B.) dialler timeout C.) dialer idle-timeout D.) dialer hang-up E.) disconnect-timer
Where is the backup configuration file stored? A.) RAM B.) ROM C.) Console D.) NVRAM
Can you explain IKE (Internet Key Exchange)?
what is frame realay.is it a circit switching technolgy if no then what technolgy it used
1.hi all, my question is how maximum number of ports can exist in a switch? 2.Which type of switching good in using and why?
Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface
Sequence and acknowledgement numbers are used for? A.) Layer transitioning B.) Flow control C.) Port number addressing D.) Reliability
CCNA 
