Interested to Buy Any Domain ? << Click Here >> for more details...
Where is the backup configuration file stored?
A.) RAM
B.) ROM
C.) Console
D.) NVRAM
- 1 Answers
- 4943 Views
- I also Faced
- E-Mail Answers
Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp
Windowing is a type of : A.) Negative acknowledgement B.) Address resolution C.) Layer transition mechanism D.) Flow control
Hi Guys I am facing one problem while configuring PAP over Point to Point links. Configuration scenario is like this. ROUTER 1: (Hostname – R1) R1(config)#username R2 password CCNA2 R1(config)#interface serial 1/1 R1(config-if)ip address 10.0.0.1 255.0.0.0 R1(config-if)#lock rate 64000 R1(config-if)#encapsulation ppp R1(config-if)#ppp authentication pap R1(config-if)#ppp pap sent –username R1 password CCNA1 R1(config-if)#no shutdown ROUTER 2: (Hostname – R2) R2(config)#usename R1 password CCNA1 R2(config)#interface serial 1/1 R2(config-if)#ip address 10.0.0.2 255.0.0.0 R2(config-if)#encapsulation ppp R2(config-if)# ppp authentication pap R2(config-if)# ppp pap sent –username R2 password CCNA2 R2(config-if)#no shutdown Now problem is that, after configure the command “ppp authentication pap” the “Line protocol” status goes down on each router. But when I disable this command using “no ppp authentication pap”, the “Line Protocol” status goes up. What could be the problem, can anyone explain it plzzz….!!! Thanks in Advance…!! Shahin..
What is a characteristic of Store and Forward switches? A.) They forward the frame before it is completely read. B.) They work at wire speed. C.) They are the same a Cut-Through switching. D.) They read the entire frame and check CRC before forwarding. E.) They decrease latency.
Mention what command you must use if you want to delete or remove the configuration data that is stored in the nvram?
Which two statements about a bridge are true? (Choose two) A. A bridge floods multicasts B. A bridge floods broadcasts C. A bridge does not flood multicasts D. A bridge does not flood broadcasts
What is the point-to-point protocol in ccna?
any body can send me CCNA voice simulator practice exam software.
A big part of the overhead on a network is broadcasts. You divide a large number of hosts into smaller individual networks and separate them with the proper device According to proper networking terminology you have created separate _______________________, User Domains Broadcast Domains Collision Areas Broadcast Areas
Which commands would assign and enable IPX on an interface ? A.) enable netware B.) enable novell-ether C.) router#(config)ipx routing D.) You must first enable IPX globally and then assign the network number to the interface . E.) enable ipx F.) router#(config-if)ipx network 4a
Which three functions are supported by connection oriented servkps? (Choose three) A. connection parameters are synchronized B. any loss or duplication of packets can be corrected C. the data packet is independently routed and the service does not guarantee the packet will be processed in order D. a data communication path is established between a requesting entity and the peer device on the remote end system
What are the two types of transmission technology use in ccna?
CCNA 
