The Internet Control Message Protocol occurs at what layer of the seven layer model? A.) Physical B.) Transport C.) Session D.) Datalink E.) Presentation F.) Network

2 Answers  

---

Identify the hardware component that stores the backup configuration? A.) RAM B.) NVRAM C.) Flash D.) ROM

1 Answers  

---

what is difference between hub and switch?

7 Answers   IBM,

---

What is the command to manually enter a static route? A.) IP route network B.) IP route C.) IP route < destination network> D.) IP route

1 Answers  

---

Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0

1 Answers  

---

What does the term Base refer to in 100BaseT A. cabling type B. singnal type C. 100 mode type D. spectrum used E. speed category

3 Answers  

---

CCNA question and answer only for networking.

0 Answers  

---

Tell me how many reserve ports?

0 Answers  

---

Novell IPX network addresses have two conferrable parts. The network administrator specifies the IPX network number. How is the node number determined? A. It is the serial number of the given device B. It is assigned as a lease by Novell DHCP C. It is also set by the network administrator D. It is usually the MAC address of one Interface E. It is downloaded by Netware Core Protocol (NCP)

1 Answers  

---

What is the difference between switch and hub?

0 Answers  

---

Identify the number range for IPX SAP filters? A.) 900 - 999 B.) 1000 - 1099 C.) 800 -899 D.) 100 - 199

1 Answers  

---

What are the different types of cables that are used in routing?

0 Answers  

---