Answer / pratik patel

Turbo machine is a set of Turbine-Compressor set to
increase the power output from IC engine.

The exhaust of the engine has enough Enthlpy to run a
Turbine. this enthalpy is utilized to run turbine which is
coupled to the compressor. This compressor compresses the
intake gases which leads to higher amount of air fuel
mixture in the engine. this results in higher power output.
another way of increasing the power output is by adding
cylinder or by increasing the volume of cylinder but this
will increase the weight of the engine to big extent.

Answer / varaprasad

A turbo machine is a machine which utilises waste(EXHAUST)
gases for its operation to convert waste heat into useful
work

Answer / princekumar688

A turbo machine is a machine which utilises waste(EXHAUST)
gases for its operation to convert waste heat into useful
work and to increase the power coming out of the engine.

Answer / mohan tayade

turbomachinery describes machines that transfer energy
between a rotor and a fluid, including both turbines and
compressors.

Answer / surendiran

A turbo machine is a machine which utilises waste(EXHAUST)
gases for its operation to convert waste heat into useful
work

Answer / alvin heavy

A turbo machine is any device that extracts energy from or
imparts energy to a continuously moving stream of fluid
(liquid or gas). The Examples of turbo machines: windmills,
water wheels, ship propeller, hydraulic and gas turbines,
pump, compressors and fans.

Answer / purna rao

A machine converts heat energy to kinetic energy.

Answer / dinesh. iiet(student )

the exhaust gas from the combustion chamber has high
temperature that gas is again send to the suction stroke of
the machine to increase the mechanical efficiency

Answer / alaa

turbomachines are the macines which the pressure &velocity
changes (kinatic energy)

What is the meaning of Moving, Non moving and slow moving ites?

1 Answers  

What is the difference between column and strut ?

0 Answers  

Hi everyone.. I attended the HAL interview... on 9th dec 2008 @ Bangalore.. the interview was 90% technical... my question are>>>>> 1) Design a rod that should withstand 1000N? (they told that the material is mild steel & they gave me the stress- strain graph for that) 2) what is the principal of hydraulic braking?? 3) whether interchangebility is possible between JIGS & FIXTURES??? 4) what is recent developement in Automobile ENGINE??? 5) abt my final year project (since i m a fresher) 6) some HR questions

3 Answers   Bhilai Steel Plant, HAL,

how much people working in railways?

3 Answers   RRB,

• Which is the latest one?

0 Answers   NTPC,

If mft not act when spark failure 3 time what problem will happen in boiler side

0 Answers  

What is the real meaning of quality

18 Answers   TATA,

can i get hpcl placement papers urgent

1 Answers   HPCL,

what is difference between stress and pressure ?

10 Answers   TATA,

where impulse turbine & reaction turbine are used?

2 Answers  

WHAT IS THE MAGNITUDE OF HARDNESS OF DIAMOND .

2 Answers  

why we made drawings in 1st and 3rd angle projection not in 2nd and 4th angle?

6 Answers   NIN,