How does cut-through LAN switching work?

0 Answers  

---

Which protocol works at the Internet layer and is responsible for making routing decisions? A.) UDP B.) IP C.) TCP D.) ARP

3 Answers  

---

Hub in star topology or bus topology?

0 Answers  

---

What does routing mean?

0 Answers  

---

here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.

3 Answers  

---

What must be true for two routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D.) Configured for PPP

1 Answers  

---

How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets

2 Answers  

---

UDP works at which layer of the DOD model? A.) Internet B.) Host-to-Host C.) Transport D.) Data Link

2 Answers  

---

while trouble shooting a network conectivty prob a technician observes that steady link light on the both work stations nic and the switch port which the workstation is conected.however when the ping comand is issuede from the work station the out message is request time out at which layer of osi model does the prob most likly exist 1 sessiom layer protocol layer datalink kayer acess layer network layer application layer i have ansered n/w layer but i am niot sure i have also posted privous question jitendera kumar sinha

3 Answers  

---

why we have to implement access list in router ??????what is the benifit and how it is configure

3 Answers   NIC, TCS,

---

What is the bit length and expression form of a MAC address? A. 24 bits expressed as a decimal number B. 24 bits expressed as a hexadecimal number C. 36 bits expressed as a binary number D. 48 bits expressed as a decimal number E. 48 bits expressed as a hexadecimal number

2 Answers  

---

Identify the 2 commands the saves the running-config to NVRAM? A.) write memory B.) copy running-config startup-config C.) write network D.) write backup

2 Answers  

---