Identify the hardware component that stores the backup configuration? A.) RAM B.) NVRAM C.) Flash D.) ROM

1 Answers  

---

Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance

1 Answers  

---

What metric does rip use? How is the metric used to indicate an unreachable network?

0 Answers  

---

HI ALL! RECENTLY I COMPLETED MY MCITP, CCNA COURSE, I AM PLANNING TO DO CCNA CERTIFICATION, ANYBODY PLZ SUGGEST ME HOW MUCH TIME (MONTHS) REQUIRED TO PREPARE FOR CCNA, BOOKS, JOB SCOPE IN INDIA, QUALIFICATION REQUIRED, ANY JOB FOR FRESHERS? YOUR GOOD ADVISE IS HIGHLY APPRECIATED. Reg.Khaleel

2 Answers   IBM,

---

Select the most correct statement regarding client port address assignment. The client port always matches the destination port. To access a web page the client uses the source port of 80 and the destination port is dynamically selected. When a client requests a web page the destination port is 80 by default and the source port for the client is dynamically selected. The client source port is 1024 to get web pages and 1055 when retrieving ftp files.

2 Answers  

---

---

Which statement about the data link connection identifier (DLCI) is true? A. It is a number that identifies a local virtual circuit in a Frame Relay network B. It is a signaling standard between the CIDE device and the Frame Relay switch C. It is the clock speed (pod speed) of the connection (local loop) to the Frame Relay Cloud D. It is the Maximum number of uncommitted bits that the Frame Relay switch will attempt to transfer beyond the Committed Information Rate (CIP)

2 Answers  

---

which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..

3 Answers  

---

Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload

1 Answers  

---

Hi Jitendera, I need ur suggestion. I completed my CCNA certification & also hving some sort of real time experience. Now i m planning to do CCNP. Little bit confusion is that whether it wud be better for me to go for CCNP ya CCNA (Security). As off my goal is to reach CCIE (Security & Switching/Routing). So tell me some solution of my confusion yaar..!!! Thanx & Regards Shahin..

1 Answers  

---

When using access lists, it is important where those access lists are placed. Which statement best describes access list placement? A. Put standard access lists as near the destination as possible. Put extended access lists as close to the source as possible. B. Put extended access lists as near the destination as possible. Put standard access lists as close to the source as possible. C. It isn't import where access lists are placed since the router will read and cache the whole list. D. Put access lists as close to corporate headquarters as possible.

1 Answers  

---

What is proxy-ARP and how it is used and configured

1 Answers  

---

what is the difference between dynamic NAT and NAT overload ? and how it works ?

4 Answers  

---