Which two steps are part of the process of creating Frame
Relay subinterfaces on a point to point connection? (Choose
two)
A. configure the router to forward all broadcast packets
B. remove any network address assigned to the physical interface
C. configure the local data link connection identifier
(DICI) for the subinterfaces
D. cartoon the total committed information rate (CIP)
available among the subinterfaces
- 1 Answers
- 3569 Views
- I also Faced
- E-Mail Answers
When using TCP, after a session is open, the applications can adjust the amount of segments they receive before sending an acknowledgment. This behaviour is known as ______________. FCS Windowing MTU adjustment Flexible Send Path
What is convergence time? A.) The update time B.) The time it takes to reload a router C.) The time it takes for a packet to reach its destination D.) The time is takes for all routers update their tables after a change takes place
What not a name of an ISP? A. MSN B. Comcast C. Verizon D. McDonalds
Which cable we connect in db-9?
What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route
How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds
Identify the 3 guidelines for routers in the same autonomous system? A.) Must be configured for IGRP or RIP B.) Interconnected C.) Assigned the same autonomous system number D.) Configured for the same routing protocol E.) Must be same model of router
Identify the OSI layer associated with bits? A.) Physical B.) Network C.) Binary D.) Data link
why we have to implement access list in router ??????what is the benifit and how it is configure
What are the advantages of using switches?
You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router
I have one problem in my network my windows xp pc in workgroup there r 2 NIC card one I have disable in and second is active. The problem is in a day some time its ip conflict with other and when I see the event log and get the conflict ip mac and scan it with LAN scanner on one is there for that mac address nic in my network I have disable dhcp also don’t know what is the problem
CCNA 
