Which is true regarding store-and-forward switching method?
A.) Latency varies depending on frame-length
B.) Latency is constant
C.) It is default for all Cisco switches
D.) It only reads the destination hardware address before
forwarding the
frame
- 1 Answers
- 3740 Views
- I also Faced
- E-Mail Answers
The following is partial output from a routing table ; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' Which routing protocol is being used? (assuming defaults have not been changed) A.) OSPF B.) RIP C.) BGP D.) IGRP
Which command do you use to set the Privileged mode password to 'clearwater'? A.) set password=clearwater B.) enable privilege password clearwater C.) enable password clearwater D.) enable login clearwater E.) enable secret password clearwater F.) ebable clearwater
switch kitne volt per work karta hai. what is frame realy. what is isdn and pri and bri.
What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network
Identify the order of the 5 step encapsulation? 1) Create the segment 2) Convert the frame to bits 3) Create the packet 4) Create the frame 5) User creates the data A.) 1,2,4,2,5 B.) 2,1,3,4,5 C.) 5,1,3,4,2 D.) 5,3,4,1,2
My question is how windows pc will act as a router? Jitendra understand this question? I again want to ask you is it possibele for windows pc to act like a router
Hi Jitendera, I need ur suggestion. I completed my CCNA certification & also hving some sort of real time experience. Now i m planning to do CCNP. Little bit confusion is that whether it wud be better for me to go for CCNP ya CCNA (Security). As off my goal is to reach CCIE (Security & Switching/Routing). So tell me some solution of my confusion yaar..!!! Thanx & Regards Shahin..
Which layer is responsible for flow control, acknowledgement, and windowing? A.) Transport B.) Network C.) Application D.) Session E.) Physical F.) Data Link
Identify the 3 major functions at layer 3 of the OSI model? A.) Forwarding process B.) Logical addressing C.) End-to-end connections D.) Path selection E.) MAC address examination F.) Network monitoring
Identify the type of hardware required to connect a Token ring network to an Ethernet network? A.) Repeater B.) TR-Enet C.) Router D.) Token Ring to Ethernet translation hub
How many total hosts are possible with a Class C address and a subnet mask of 255.255.255.252? A. 4 B. 30 C. 60 D. 62 E. 112 F. 124
I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
CCNA 
