Answer / a. nagaraja

Refractory work will be done in the boiler at the bottom
four sides, manhole doors,burner area, peephole area and at
the top of the boiler. To heat the refractory from low
temp. to high temp, slow firing is done. So that
refractory will be gripped. And also to remove the
unwanted particles like sand, rust, oil and others from
boiler tubes and headers slow firing is done.

TSP and NaoH chemicals will be added with D.M water and it
will be filled in the boiler. The prs. will raise slowly
up to max. 15kg/sq.cm

Why should we hire you over the others waiting to be interviewed?

0 Answers  

---

. What is a magnetic valve of refrigeration system?

0 Answers   RRB,

---

draw neat sketch of pirani gauge with wheatstone bridge circuit to measure output. discuss its construction working princple

0 Answers   Ksb,

---

What is the purpose of scrapper ring

0 Answers   RRB,

---

can anybody says what is mean by BS 1/8" thread?

1 Answers  

---

---

I have 1010 KVA Generator when i run the DG set for 5 to 6 hours the couplling (couplling joint in between engine & alternator) bolts are getting loose what is the reason & what is the remedy over this??????????

7 Answers  

---

what is cast iron?

5 Answers  

---

If a fixed gear having 200 teeth is in mesh with another gear having 50 teeth.The two gear are connected by an arm.What will be the number of turn made by the smaller gear for one revolution of arm about the center of bigger gear? Any effort is appreciable witha proper logic..

8 Answers  

---

Why and what cause of leak fuel oil in high pressure pipe of main engine?

4 Answers  

---

What are the performance expectations of this position over the first 12 months?

1 Answers  

---

What is compound gage

0 Answers   RRB,

---

What is the diffrence between four strock and two strock ic engine

14 Answers   Alkem Labs, Mechanical,

---