Identify the command to display the hardware platform information? A.) show all B.) show platform C.) display hardware D.) show version

1 Answers  

---

What is the difference between csma/ca?

0 Answers  

---

What is formula of hold down time of eigrp protocol?

0 Answers  

---

You are given the IP address of 172.16.2.160 with a subnet mask of 255.255.0.0. What is the network address in binary? A. 10101100 00010000 B. 00000010 10100000 C. 10101100 00000000 D. 11100000 11110000

2 Answers  

---

What is the result of segmenting a network with a router into segments 1 and 2? A. It increases the number of collisions B. It decreases the number of broadcast domains C. It connects segment 1 and broadcasts to segment 2 D. It connects segment 1 and broadcasts from genre to segment 2

2 Answers  

---

When discussing static routes, what is the gateway parameter used for? A.) Determining the dynamic route B.) Defining the subnet C.) Defining the Administrative Distance D.) Determining the next hop

1 Answers  

---

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

2 Answers  

---

IPX routing updates occur how often? A.) Every 30 seconds B.) Every 60 seconds C.) Only as needed D.) When the remote router asks for an update

1 Answers  

---

Novell IPX network addresses have two conferrable parts. The network administrator specifies the IPX network number. How is the node number determined? A. It is the serial number of the given device B. It is assigned as a lease by Novell DHCP C. It is also set by the network administrator D. It is usually the MAC address of one Interface E. It is downloaded by Netware Core Protocol (NCP)

1 Answers  

---

thnx jitender...its me shridh...m working for SG ltd..the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected?? plz tel me jitender how to resolve ths problem? as u sd loop in switch is the primary cause of ths....i wanna know how to resolve it...thnx for ur replys jitender sinha.

2 Answers  

---

Suppose we have some switch in network and we are running RSTP how much convergence time will be there if one link down

0 Answers   Infosys,

---

How do you disable CDP on the entire Router? A.) Router#no cdp run B.) Rotuer(config-if)# no cdp enable C.) Router(config)# no cdp enable D.) Router(config)# no cdp run

1 Answers  

---