what is diffrence b/w -48vdc and +48vdc ?
Answer / sakthivel
in telecommunication tower network we use -48 volts and + 48
volts and -48cvolt are main power supply in communication
field
Is This Answer Correct ? | 0 Yes | 6 No |
Why the power factor improvement is so important in industrial loads
What_is_mean_by_negative_dc_voltage? why we use -48v except +48v in DC power supply systems.
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
how to create new innovation what are the supporting sources in the electrical field for Electrical engineers.....?
what is the principle of switchgear and its function
define reflection method?
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
lorteny method
why earthing point in the 6amps/16amps socket bigger than the remaining (Phase & Neutral)points.
we want install 11KV generator to supply power 12km far from the power house.Load to be fed is 1MW.which conductor should we use and wat will be transmission line losses?
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?