Answer / hiraman

Layer2 forward (L2F)protocol is a tunneling protocol developed
by Cisco systems to establish the VPN connections over the
internet

As the system administrator, you type "ppp authentication chap pap secret". Which authentication method is used first in setting up a session? A. secret B. PAP C. CHAP D. PPP/SLIP

1 Answers  

---

CO is an acronym for which of the following? A.) Central Office B.) Capital Office C.) Central Operator D.) Company Office

1 Answers  

---

Identify the default serial encapsulation? A.) ISDN B.) HDLC C.) SDLC D.) Frame Relay E.) PPP

2 Answers  

---

What is the distance limitation for 100BaseT? A. 607 ft B. 25 Meters C. 1,000 ft D. 185 Meters

1 Answers  

---

The following is partial output from a routing table, identify the 2 numbers in the square brackets; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' A.) 100 = metric, 1300 = administrative distance B.) 100 = administrative distance, 1300 = hop count C.) 100 = administrative distance, 1300 = metric D.) 100 = hop count, 1300 = metric

1 Answers  

---

Identify the 3 guidelines for routers in the same autonomous system? A.) Must be configured for RIP B.) Interconnected C.) Assigned the same autonomous system number D.) Configured for the same routing protocol E.) Must be same model of router

1 Answers  

---

Hi, gys i am Hasnain alamI want to get certification how do it ? please sugges me.

1 Answers   IBM,

---

hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

1 Answers   IBM,

---

Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Router# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes

1 Answers   ABC,

---

Tell us the name of algorithm of eigrp protocol?

0 Answers  

---

what is subnetting?

8 Answers   HCL,

---

Identify IPX GNS and it's purpose? A.) Go Network Server - sends a print job to a network server B.) Get Nearest Server - locate the nearest server C.) Guaranteed Network Services - allocates resources to users D.) Get Notes Server - locates Domino Server

1 Answers  

---