Answer / anand joshi

Zener diode can be operated in reverse bias conditions also.

Answer / nithi

The main difference between the two is the doping level.
Zener diode is heavily doped. Most of the simple diodes are
always used in forward biased condition. Where as Zener
diode is always used in reverse biased condition(Voltage
regulator)

Answer / ab

A aimple diode works in single direction but a zener diode
works in both the directions.

what is the difference between impact force and sudden force?

4 Answers  

---

Name the types of welding?

0 Answers  

---

sir I have applied for HPCL management trainee..Can i get previous MECHANICAL ENGINEERING question paper..? stalin

3 Answers   Bhel, HPCL, IOCL, RRB,

---

Which is the hardest material on earth?

0 Answers  

---

Where is the maximum temperature in refrigeration cycle? a.Between evaporator & compressor. b.At Compressor c.Between compressor and condensor. d.At condensor

12 Answers   HAL,

---

How i injecter setting qsk series cummins engine and i can using click type torqurench or dial gauge type

0 Answers   Cummins,

---

Tell me how many btu per hour equals 1 ton of air conditioning?

0 Answers  

---

25 questions in 25 minutes were asked by L&T corein mechanical engg test on 28 nov 2011 are as follows:- L&t mechanical consists of 1> airfuel ratio 2> mollier chart for flow rate 3>homogeneous or hetreogeneous mixture 4>sublimation curve 5>effect on room temperature when fridge is opened 6>cop of refrigerator 7> punching and piercing uses shear or not 8>method not used for tapering 9>forming method not used for productn 10>numerical regardng no.of cuts 11>flow of chip is controlled by which parameters 12> property important for impact loading 13>stifness of spring when it is cut into 2 pieces 14> device reqd for energy fluctuation 15> property on which rivet is selected 16>crowning to prevent flat belt pulley errors like undercut 17>cavitation occurs at which stage 18>qstn regardng inventory control 19>for ship vessel industry what sort of plantlayout reqd 20>value engg definition 21> qstn on how the extnsn occurs for uniform loading 22> qstn regardng stress actng on the shaft23>maximum value of mohr's circle diameter 24>qstn regardng meshing of teeth 25>qstn on helical gear reqrd better read G.K.PUBLISHERS GATE PAPERS ESPECIALLY FROM 1993 to 2003 ESPECIALLY THEORY QUESTIONS RATHER THAN NUMERICAL QUESTIONS

0 Answers   L&T,

---

What are the advantages of white metal?

0 Answers  

---

what is the basic optimal difference among isothermal,isentropic and adiabatic processess( with charts of each)??

0 Answers   BARC, NTPC,

---

What are the causes of low compression in the main engine?

0 Answers   RRB,

---

purpose of centrifugal pump casing wear ring and impeller wear ring

10 Answers   Jyoti Ltd, Kirloskar, NPCIL,

---