How vaccum is formed to create a vaccum interrupter or
anything related with vaccum?
Answers were Sorted based on User's Feedback
Answer / k.prakashchandra
Just like vacuum created inside a bulb
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / nomana
Vacuum ac unit after replacing compressor, so it does -0 and connect the charger line it is suction that call a vacuum, But bulb safe working zone using compressor air which turn alternator and I you ask that question about bulb. I also need ask you What is PI and also I got DC motor 752 shunt on back yard up to could I run this motor without SCR to clean the communicator segment after replacing spring gear and brushes
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / louis
If 11KV out put from generatore for power consumer what is load setting from governor speed signal for the main breaker setting ?
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / louis
I would like know, how could change rotation of dc motor of shunt
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / louis
Does high torque dc motor can use one SCR one silicon control to operator windless system or top-drive
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / louis
I have dc series motor load increase amp what does voltage increase or decrease ? and field current at 48 amp
| Is This Answer Correct ? | 0 Yes | 0 No |
what is the difference between Miniature circuit breaker & motor control circuit breaker ?
i wasted one year for the job after completed my btech what can i say about 1year time in interview
What is the method of Tan delta test for power Transformes and why it is required.
DC transmission
when we connect the capacitor bank in series
what is creepage distance
In order that work may be done:(a) Two wires are necessary(b) The circuit must have a switch(c) Coal must be burnt(d) A supply of energy is required
Why we are use dol starter up to 10 hp
Why Motors are generally supplied with 3 core cables??? why not 4C??
what was the function of the auxillary relay?
every motors written in name plate IP 55 what is this?
Why the pointer of earthing of 3 pin top is made thick and long compared to the phase and neutral pin ?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)