Identify the purpose of the Trace command?
A.) Explorer packet transmitting routing information
B.) Test connectivity
C.) Determine the path a packet is taking through the network
D.) Transmits user data when buffers are full
- 2 Answers
- 5466 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / santhosh
C.) Determine the path a packet is taking through the
network.
| Is This Answer Correct ? | 2 Yes | 0 No |
You create the following standard access-list access-list 1 deny 1.1.1.1 access-list 1 deny 2.2.2.2 int e0 ip access-group 1 in Which of the following statements are true, with regard to traffic flowing into E0? A.) This will stop IP packets with a source address of 1.1.1.1 only. B.) This will stop all IP packets. C.) This is an invalid configuration. D.) This will stop no IP packets. E.) This will stop IP packets with a source address of 2.2.2.2 only. F.) This will stop IP packets with a source address of 1.1.1.1 and 2.2.2.2.
Identify the 2 commands the saves the running-config to NVRAM? A.) write memory B.) copy running-config startup-config C.) write network D.) write backup
what is standard and extended acess list? what are the commands for extended and acess list?
What is bgp?
can anyone tell me which r the companies hiring freshers ( ccna ) in mumbai
Value in which type of access list?
Which protocols are link states?
What is the mau?
What are the Timer of RIP, IGRP, EIGRP and OSPF Routing Protocol?
What is size of ipv4 mac address?
What is the juncture at which the CPE ends and the local loop portion of the service begins? A. Demarc B. CO C. Local loop D. Last-mile
What is the point-to-point protocol in ccna?
CCNA 
