Answer / vikramsingh11

I think, the time of routing update table is every 90
seconds, & invalid timer is 270 seconds, and the flush timer
is 630 secods in Interior Gateway Routing Protocol. it's
same on EIGRP..... bcoz igrp is a distance vector protocol
and it is a cisco proprietry procol, this means, that IGRP
supports maximum hop count of 255 and only support cisco
routers.This is helpful in last network...

Identify the 2 commands to copy a configuration from a TFTP server to RAM? A.) configure network B.) configure overwrite C.) copy backup-config running-config D.) copy tftp running-config

2 Answers  

---

During encapsulation, in which order is information packaged? A. Data, Packet, Segment, Frame B. Segment, Data, Packet, Frame C. Data, Segment, Packet, Frame D. Packet, Data, Segment, Frame E. Frame, Data, Segment, Packet F. Bread, Peanut Butter, Jelly, Bread

3 Answers  

---

What is the mau?

0 Answers  

---

Identify the command that configures serial0 for PPP encapsulation? A.) Router(config)# encapsulation ppp B.) Router(config-if)# encapsulation serial ppp C.) Router(config-if)# encapsulation ppp D.) Router# encapsulation ppp

2 Answers  

---

what is telnet,ssh?? what is the perpose of this? wer r this configured and how to configured??

2 Answers  

---

When setting up a WAN network, everything outside of the Demarc is not owned by the customer. Which of the following are not owned by the customer? A.) The T1 line. B.) LAN C.) The Router D.) DTE E.) PC's F.) CO

1 Answers  

---

intial information of packey occur on which layer application sessions physical mine answer physical

1 Answers  

---

Which command will display adjacent routers found by the Cisco Discovery Protocol? A.) show all B.) show cdp entry C.) show ip neighbors D.) show cdp neighbor detail E.) show cdp neighbor F.) show neighbor

2 Answers  

---

Which of the following statements is false? If your Frame Relay link does not support inverse ARP, you must manually map DLCIs to network Address. One of the major advantages of Frame Relay is its ability to connect to multiple PVCs using only one physical link. DLCI addresses are determined by the network administrator when installing the network. Which of the following statements is false? If your Frame Relay link does not support inverse ARP, you must manually map DLCIs to network Address. One of the major advantages of Frame Relay is its ability to connect to multiple PVCs using only one physical link. DLCI addresses are determined by the network administrator when installing the network. In order for two ends of virtual circuits to communicate using Frame Relay, their network addresses must be mapped to DLCIs.

2 Answers   Wipro,

---

When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes

1 Answers  

---

Identify the switching method that receives the entire frame then dispatches it? A.) Cut-through B.) Receive and forward C.) Store and forward D.) Fast forward

1 Answers  

---

With one method for transmitting frames through a switch, the switch receives the complete frame and checks the frame CRC before forwarding the frame. What is the switch transmission method called? A. CSMA/CD B. Full Duplex C. Cut-Through D. Half-Duplex E. Fragmentation F. Store and Forward

2 Answers  

---