Identify the length of an IPX address and it's components?
A.) 80 bits, 48 bits network and 32 bits node
B.) 32 bits, 16 bits network and 16 bits node
C.) None of the above
D.) 80 bits, 32 bits network and 48 bits node
- 1 Answers
- 3675 Views
- I also Faced
- E-Mail Answers
What are the advantages of a layered model in the networking industry?
Which protocol comes under hybrid dynamic type?
9. Which STP state prevents the use of looped paths? A. Blocking B. Listening C. Learning D. Forwarding
Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface
You have typed "ping" 172.16.101.1 and get the following display: Type escape sequence to abort. Sending 5, 100-byte ICMP Echoes to 172.16.101.1, timeout is 2 seconds: .!!!! What does the "." signify? A. That one message timed out. B. That all messages were successful. C. That one message was successful. D. That one message completed in under the allotted timeframe.
hi all.. can any one explain the complete topology of stp and rstp how it works . root swtch connects to a root port and then root port conenct to other switchs designated port. i was going thru his site http://www.cisco.com/en/US/tech/tk389/tk621/technologies_whi te_paper09186a0080094cfa.shtml in which DR also exist on root switch only which makes my understanding grim.I had a diff notion of stp all together. please post asap. and if possible refer a url so thst i can read it my self .. thanks
You want to enable both arpa and snap encapsulation on one router interface. How do you do this? A. The interface can handle multiple encapsulation types with no extra configuration. B. Assign two network numbers, one for each encapsulation type. C. Enable Novell-ether to run multiple encapsulation types. D. Both arpa and snap are enabled by default so you don't have to configure anything.
Difference between Distance vector, Link state protocols
If a frame is received at a switch and only the destination hardware address is read before the frame is forwarded, what type of switching method is this? A.) Store-and-drop B.) Latency C.) Store-and-forward D.) Cut-through
Which layer called error detection layer?
How do you find valid hosts in a subnet?
Significance of IP helper-address Command on SW? Is it necessary to put this command?
CCNA 
