Answer / shashank

Answer: D

Answer / guest

Answer: B

If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI

1 Answers  

---

'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers

2 Answers  

---

What does a router do with a packet that it does not have a destination network for? A.) Sends it to the Serial port B.) Drops the packet C.) Sends it back out the same interface it received it in D.) Forwards the packet to the next hop

1 Answers  

---

How can an Ethernet switch improve network performance? Choose three

2 Answers  

---

Hi, gys i am Hasnain alamI want to get certification how do it ? please sugges me.

1 Answers   IBM,

---

Which command do you use to set the Privileged mode password to 'clearwater'? A.) set password=clearwater B.) enable privilege password clearwater C.) enable password clearwater D.) enable login clearwater E.) enable secret password clearwater F.) ebable clearwater

2 Answers  

---

What is the IEEE specification for Spanning Tree Protocol? A.) 802.9 B.) 803.ud C.) 803 D.) 802.1d

1 Answers  

---

Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'

1 Answers  

---

Which OSI layer provides best effort end to end packet delivery? A.) Data-Link B.) Presentation C.) Network D.) Transport E.) Physical F.) Application

2 Answers  

---

Which command would show all Ethernet interfaces with IPX configured on them? A.) show interface ipx ethernet B.) show ipx interface C.) show ipx interface ethernet D.) show ipx E.) show version F.) show run

1 Answers  

---

Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp

1 Answers  

---

What is the difference between an igp and an egp?

0 Answers  

---