Answer / guest

Answer:B

Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload

1 Answers  

---

which defined peer ip address an local subnet belong to crete? (Choose two)

0 Answers  

---

How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds

2 Answers  

---

What is the network brouter?

0 Answers  

---

Which protocol will send a message to routers if a network outage or congestion occurs? A.) ARP B.) TCP C.) IP D.) ICMP

1 Answers  

---

What is the default routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) Bandwidth and delay D.) Hop count

2 Answers  

---

1.hi all, my question is how maximum number of ports can exist in a switch? 2.Which type of switching good in using and why?

4 Answers   HCL,

---

Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102

1 Answers  

---

Which command listed below sets the banner message when someone connects to the router? A.) message # B.) banner # C.) login banner # D.) description # E.) login description # F.) banner motd #

2 Answers  

---

6. Which device can create smaller networks and stop broadcast storms by default? A. Repeater B. Bridge C. Router D. Gateway

4 Answers  

---

Choose the following that are benefits to segmenting with router: A.) Flow Control B.) Manageability C.) Multiple Active Paths D.) Explicit packet lifetime control

1 Answers  

---

Which two steps are required to confound and apply standard access lists on an interface? (Choose two) A. define an access list number and its parameters B. enable an interface to become part of the access list group C. define the number of access lists to be supported on an interface D. copy the access list definition to each interface that will support it

2 Answers  

---