We know that TCP provides connection oriented services, what else does it provide? A.) FECN & BECN B.) Path discovery. C.) Flow control and error checking. D.) Name resolution. E.) File manipulation.

1 Answers  

---

How many collision domains are in switch?

0 Answers  

---

Which layer is responsible for framing? A.) Application B.) Data Link C.) Physical D.) Network E.) Transport

3 Answers  

---

What is true about Link-State protocols? A.) They maintain a more complex table than distant vector protocols B.) They maintain a less complex table than distant vector protocols C.) They use routing ports D.) The maintain backup copies of the IOS

2 Answers  

---

Identify the 3 pieces of hardware you would not install to prevent broadcasts? A.) Switch B.) Repeater C.) Bridge D.) Router

1 Answers  

---

Which type of switching is considered to be 'wire speed?' A.) Cut-Through B.) Multiplexed C.) Inverted D.) Layer 4 E.) Store and Forward F.) Layer 3

2 Answers  

---

There is an emergency fall-back 'skeleton' IOS stored in read only memory on all Cisco routers. What command would make the router load the IOS from Read Only Memory? A.) reload rom B.) boot system rom C.) load ios bootflash D.) load ios rom E.) bootsystem skeleton

3 Answers  

---

Suppose we have 4 switches runing in VTP mode. So when i create a VLAN in Server Switch this VLAN info reflect in all other switch. So question is - A) Suppose i m practicing this scenario in BOSON software, When a create a VLAN in server switch n ADD ports of switch to that VLAN, the same number of ports of client switch also belongs to dat VLAN. For example - In switch A (Server mode), i create a VLAN 7 name Hyderabad & port number 1, 2 & 3 put into this VLAN. Another Switch B (Client mode), its also showing that port number 1,2 & 3 belong the same VLAN. How cud it possible... As we know, VTP share only VLAN configuration information. Cud anyone explain it please....!!!! B)Same thing, when i m practicing in PACKET TRACER 5.0, its only showing that VLAN configuration information is shared. No port information is shared at all. I can manually configure individual switch port to respective VLAN as our wish. Cud anyone explain it please..!!!

3 Answers  

---

hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

1 Answers   IBM,

---

Which of the following will apply IPX sap access list 1010 for incoming traffic, assume you are at the interface configuration? A.) ipx input-sap-filter 1010 in B.) ipx input-sap-filter 1010 C.) ipx access-group 1010 in D.) ipx access-list 1010 in

2 Answers  

---

What is ccna?

0 Answers  

---

What is a Window in networking terms?

0 Answers  

---