Interested to Buy Any Domain ? << Click Here >> for more details...
3. What does a bridge use to segment a network?
A. IP Addresses
B. Broadcasts
C. Application data
D. Media Access Control addresses
- 2 Answers
- 4894 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / kapilasdhir
Answer: D
Bridges can only read frames and filters by MAC (hardware)
address.
| Is This Answer Correct ? | 7 Yes | 0 No |
What is the different between console port and auxiliary port?
What is EIGRP?
To monitor ipx traffic on a network, what command would you use? A. debug ipx transaction B. show ipx traffic C. show ipx events D. display ipx traffic
Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses
Which of the following is a layer 2 device? A.) Switch B.) Bridge C.) Repeater D.) Hub
Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#
In distance-vector routing, there is a problem known as the 'count to infinity' problem. What is the most direct solution to this? A.) Defining a Maximum. B.) You can not solve the 'count to infinity' problem with a distance vector protocol. C.) Poison Reverse. D.) Triggered Updates. E.) Split Horizon.
Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department
The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full
For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix
what is meant by wild card mask and why can't we use in eigrp ?
Hi, Can any one please tell me the experience of their CCNA interview,and please tell me all the questions they asked in the interview. Many Thanks...
CCNA 
