Answer / guest

Answer: A

UDP is connectionless, and does not provide error checking. But

remember, error checking can occur at other layers too.

Which command would show all Ethernet interfaces with IPX configured on them? A.) show interface ipx ethernet B.) show ipx interface C.) show ipx interface ethernet D.) show ipx E.) show version F.) show run

1 Answers  

---

The Internet Protocol (IP) occurs at what layer of the seven layer model? A.) Physical B.) Presentation C.) Network D.) Datalink E.) Session F.) Transport

3 Answers  

---

Dear Mr. JITENDERA KUAMR SINHA how are and how is your family? Anyway can u send me your personal email address?

4 Answers  

---

What is CSU/DSU & explain the function????

6 Answers   Cisco,

---

Which command sets IGRP as the routing protocol for autonomous system 100? A. Router(config)#igrp 100 B. Router(config)#network 100 C. Router(config)#router igrp 100 D. Router(config)#enable igrp 100

1 Answers  

---

which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..

3 Answers   Wipro,

---

what is route aggregation

2 Answers  

---

Identify the type of hardware required to connect a Token ring network to an Ethernet network? A.) Repeater B.) TR-Enet C.) Router D.) Token Ring to Ethernet translation hub

1 Answers  

---

You want to enable both arpa and snap encapsulation on one router interface. How do you do this? A. The interface can handle multiple encapsulation types with no extra configuration. B. Assign two network numbers, one for each encapsulation type. C. Enable Novell-ether to run multiple encapsulation types. D. Both arpa and snap are enabled by default so you don't have to configure anything.

2 Answers  

---

Identify the command to view the configuration-register value? A.) show register B.) display config-register C.) show config D.) show version

1 Answers  

---

What is the subnetmask of / 27 in network based and host based?

0 Answers  

---

Identify the effect of Ctrl-Z? A.) Exits back to privileged exec mode B.) Disconnect from the router C.) Abort the ping operation D.) Exits privileged exec mode

3 Answers  

---