What are the 3 ways routers learn paths to destination networks?
A.) Dynamic
B.) Static
C.) Routing tables
D.) Default
Answers were Sorted based on User's Feedback
Answer / guest
Answer: A B D
There are three methods in which routers can learn paths to
destination
networks, they are:
1) Static - The administrator manually enters the routes.
2) Dynamic - A routing protocol is used.
3) Default - A gateway of last resort is set.
Is This Answer Correct ? | 30 Yes | 5 No |
What does -1 mean in an extended IPX access-list? A.) Any IP address B.) Deny all C.) Deny host D.) Any host or any network
The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independence and what else? A.) Provides Windowing. B.) Provides flow control. C.) Provides SAP's (Service Access Points). D.) The Datalink layer does not have sublayers. E.) Provides SAP's (Service Advertising Protocol). F.) RIP Updates.
Routers that have Flash memory typically have a ore loaded copy of place IOS software. Which command should you use to make a backup copy of the software image onto a given network server? A. copy flash tftp B. save copy to tftp C. write backup tftp D. write, backup -server-name- E. copy backup to -server-name-
What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message
What is the link state routing protocol in the TCP/IP protocol stack? A. IP B. IS-IS C. NLSP D. OSPF E. RIP version 2
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
If line up, but protocol down which layer should be troubleshot?
Given the following output, how can we close Telnet session 2? (Choose two) CCNA2620#show sessions Conn Host Address Idle Conn Name 1 131.108.100.152 131.108.100.152 0 131.108.100.152 *2 126.102.57.63 126.102.57.63 0 126.102.57.63 ❍ A. Press the Enter key and enter exit. ❍ B. Enter disconnect 2. ❍ C. Press the Enter key and enter disconnect 2. ❍ D. Enter close 2.
Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename
what is native vlan any one explain sooraj
Which layer defines the physical topology? A.) Application B.) Transport C.) Network D.) Data Link E.) Physical F.) Session
Define logical topology.