Answer / prashant

Dear u contact CISCO help line no

Which command displays the IPX SAP table? A.) show ipx sap B.) show sap C.) show ipx interface D.) show ipx servers E.) show ipx

1 Answers  

---

Suppose we are having two router i.e. Router1 and Router 2 connected with each other on Serial Link,Router Network having ip 192.168.1.0/24. 1> which ip is used at router1 and router2 interface? 2>Which Command is used to assign ip to router1 and router2 interface?

1 Answers  

---

How do you configure a Cisco router to route IPX?

0 Answers  

---

Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces

1 Answers  

---

1.i have to pcs in the network 192.168.1.1 202.55.88.16 2. if that fails shud go through 122.16.1.3 and and if that comes back active it shud go through 202.55.88.16 itself

1 Answers  

---

When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes

1 Answers  

---

Which statement is true regarding full duplex? A.) Allows for transmission and receiving of data simultaneously B.) Only works in a multipoint configuration C.) Does not affect the bandwidth D.) Allows for transmission and receiving of data but not a the same time

2 Answers  

---

Hi Gyes There are any sites where we can practice online for ccna exams?Plz let me know because i get time to study in my working hours only

1 Answers  

---

What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route

1 Answers  

---

What is the command for change serial cost?

0 Answers  

---

What is link aggregration?? How many types of protocol are used on that???

3 Answers   Hathway,

---

What is default time of hello packets in ospf?

0 Answers  

---