Answer / jitendera

Not sure what you are asking about ? please explain the
Question properly and please donot Revile yours Pb ip

If you are running Token Ring with Novell IPX routing, which encapsulation should you use? A.) SAP B.) SNAP C.) 802.5 D.) 802.2

1 Answers  

---

What is default cost of serial interface in ospf?

0 Answers  

---

What is the difference between csma/cd?

0 Answers  

---

In eigrp metric parameters which 2 options are enable by default?

0 Answers  

---

What is the difference between ‘bit rate’ and ‘baud rate’?

0 Answers  

---

Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network

3 Answers  

---

Identify the number range for IPX SAP filters? A.) 900 - 999 B.) 1000 - 1099 C.) 800 -899 D.) 100 - 199

1 Answers  

---

Which command-line keywords are valid for choosing Frame-Relay LMI types? A.) itu-t B.) dlci C.) ansi D.) rfc 1544 E.) cisco F.) q933a

1 Answers  

---

Which layer is responsible for providing mechanisms for multiplexing upper-layer application, session establishment, and tear down of virtual circuits? A.) Session B.) Network C.) Physical D.) Transport E.) Application F.) Presentation

1 Answers  

---

Identify the command that displays traffic statistics on serial0/1? A.) display interface serial0/1 B.) show interface serial0/1 C.) show seria0/1 stats D.) show interface serial0/1 stats

1 Answers  

---

Identify the prompt displayed if in privileged exec mode? A.) Router(config)# B.) Router# C.) Router> D.) Router(priv)#

2 Answers  

---

What IP command would you use to test the entire IP stack? A.) Stack-test B.) Arp C.) Telnet D.) Ping E.) Trace

2 Answers  

---