Answer / guest

Answer: C

Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route

1 Answers  

---

How do you depict an IP address?

0 Answers  

---

Which ipsec rule is used for the olympia branch and what does it define?

0 Answers  

---

The administrator of a comapny needs to ensure that a web server in their network is accessible from the Internet. Since the network uses private addressing, this requires an IP-to-registered-address mapping. The following command is entered on the router: router(config)# ip nat inside source static 192.168.2.1 198.18.1.254 After unsuccessful results from a ping to the Internet, the administrator issues the show ip nat translations command and the output is blank. What could be the problem with the NAT configuration for this mapping? A. The keyword overload is missing from the command. B. The administrator needs to define a NAT pool first. C. An access list must be defined to create static NAT translations. D. The interfaces need to be configured for NAT.

4 Answers  

---

What are the Timer of RIP, IGRP, EIGRP and OSPF Routing Protocol?

1 Answers  

---

What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.

3 Answers  

---

Which router command allows you to determine if an IP access list is enabled on a particular interface? A. Router# show ip interface B. Router> show access-list C. Router# show ip access-list D. Router> show interface ip access-list E. Route 1 P.O. box 198

2 Answers  

---

What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a

3 Answers  

---

what is standard and extended acess list? what are the commands for extended and acess list?

3 Answers   HCL,

---

IGRP supports a feature that allows traffic to be distributed among up to 6 (4 default) paths to provide greater overall throughput and reliability. What is this called? A. unequal-cost load balancing B. equal-cost load balancing C. proportionate load balancing D. low cost load balancing

1 Answers  

---

Which of the following are Session Layer standards? A.) ASCII and EBCDIC B.) MPEG and MIDI C.) RPC and SQL D.) JPEG and PICT

3 Answers  

---

My question is how windows pc will act as a router? Jitendra understand this question? I again want to ask you is it possibele for windows pc to act like a router

2 Answers  

---