Answer / guest

Answer: A

Instead of waiting on a pre-set periodic interval (before
sending the

routing table), DV routing protocols can send triggered
updates to

immediately notify the neighbor routers. Hold down timers,
Poison

Reverse, and Split Horizon are features that are used to
avoid routing

loops.

When using access lists, it is important where those access lists are placed. Which statement best describes access list placement? A. Put standard access lists as near the destination as possible. Put extended access lists as close to the source as possible. B. Put extended access lists as near the destination as possible. Put standard access lists as close to the source as possible. C. It isn't import where access lists are placed since the router will read and cache the whole list. D. Put access lists as close to corporate headquarters as possible.

1 Answers  

---

What is the difference between tracert and traceroute?

0 Answers  

---

Which ISDN protocol prefix specifies switching and signalling? A.) I B.) E C.) Q D.) S

1 Answers  

---

what is AD Value?

5 Answers   Cisco, Infosys,

---

What is window in networking terms?

0 Answers  

---

---

You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router

3 Answers   TCS,

---

HOW MPLS IS DIFFERENT FROM OSPF? WHY NOW A DAYS MPLS IS PREFERED OVER ANY NETWORK PROTOCOL?

1 Answers   Bank Of India, TCS,

---

Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) Ping D.) Console E.) Trace

2 Answers  

---

Which layer of the 7 layer model is responsible for representing the application information between 2 different OS's? For example, converting ASCII to EBCIDIC. A.) Transport B.) Application C.) Physical D.) Session E.) Presentation F.) Network

2 Answers  

---

Tell me how many hop counts are by default and how much you can increase in eigrp protocol?

0 Answers  

---

What is the difference between switch and hub?

0 Answers  

---

Switching methods include cut-through, store and forward, and a modified version of the first two methods. Which statement about switching methods is true? A. The store and forward method has low latency B. The cut through method of switching has high latency C. The modified version holds the packet in memory until 50 percent of the packet reaches the switch D. The modified version holds the packet in memory until the data spoon of the packet reaches the switch

3 Answers  

---