When we use router?

0 Answers  

---

The default routing protocol for IPX is IPX RIP. How do you view the routing updates sent and received by the router? A.) debug ipx routing B.) debug ipx routing activity C.) debug rip D.) show ipx routing E.) sh ipx F.) debug ipx rip

4 Answers  

---

State the difference between dynamic IP and static IP addressing?

0 Answers  

---

Identify the command to configure the router to boot from an alternate IOS located in flash? A.) boot system flash IOS.exe B.) boot system tftp IOS.exe 172.16.5.1 C.) boot system alternate IOS.exe D.) boot system rom IOS.exe

1 Answers  

---

What command can you type to view the connections after telneting into multiple routers simultaneously? A.) sh users B.) sh ports C.) sh host D.) sh sessions

1 Answers  

---

---

Identify the OSI layer responsible for end-to-end connections? A.) Network B.) Transport C.) Session D.) Data link E.) TCP

4 Answers  

---

What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II

1 Answers  

---

Most routing protocols recognize that it is never useful to send information about a route back out the direction from which the original packet came. This is an example of which routing technology? A.) Split Horizon B.) LMI C.) Triggered Updates D.) Poison Reverse E.) SYN, ACK F.) DLCI

1 Answers  

---

When editing a line in the CLI mode, what does 'CTRL-A' do? A.) Moves you to the previous command. B.) Moves you to the next word. C.) Moves you to the end of the line. D.) Moves you to the next command. E.) Moves you to the beginning of the line.

1 Answers  

---

Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

2 Answers  

---

There are 2 types of PPP authentication supported by the Cisco IOS. What are they? A.) PAP B.) PREDICTOR C.) MD5 D.) CHAP E.) STACKER F.) MSCHAP

4 Answers  

---

What is the juncture at which the CPE ends and the local loop portion of the service begins? A. Demarc B. CO C. Local loop D. Last-mile

1 Answers  

---