Brielfly explain the conversion steps in data encapsulation


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More CCNA Interview Questions

You are given the IP address of 172.16.2.160 with a subnet mask of 255.255.0.0. What is the network address in binary? A. 10101100 00010000 B. 00000010 10100000 C. 10101100 00000000 D. 11100000 11110000

2 Answers  


What are the two most common transport layer protocols? UDP TCP IPX ARP

3 Answers  


What is Phase od VPN in site to site and what information you will require to configure a SITE to SITE VPN

0 Answers   Infosys,


CPE is an acronym for which of the following? A.) Customer Premise Equipment B.) Central Processing Engineering C.) Customer Process Equipment D.) Central Processing Equipment

2 Answers   Cisco,


How many collisions are caused by transmitting and receiving frames simultaneously in a full-duplex Ethernet technology? A. one B. two C. none D. several

1 Answers  






If bandwidth will increase what will happen?

0 Answers  


What is the Cisco name for the encapsulation type used on a serial interface? A. HDLC B. SDLC C. SAP D. SNAP

3 Answers   HCL,


A traffic light is an example of what type of mechanism? A.) Collision detection B.) Flow control C.) Sequence numbering D.) Network management

1 Answers  


Why OSI layers having 7 layers instead of one layer.

8 Answers   HCL,


Which command verifies encapsulation as well as Layer 1 and Layer 2 statistics on a router configured for Frame Relay? A. show ip B. show interface C. show statistics D. show frame-relay

1 Answers  


Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end B.) Half duplex transmission between stations is achieved by using point to multipoint Ethernet and Fast Ethernet C.) With Half Duplex transmission logically circuits feed into a single cable creating a situation similar to a one way bridge D.) Half Duplex transmission between stations is achieved using Point to Point Ethernet & Fast Ethernet

2 Answers  


What command can be used to test IPX connectivity? A.) Ping 2e.000.0045.8923 B.) Ping 192.168.100.1 C.) Ping ipx 2e.0000.0045.8923 D.) Ipx ping 2e.0000.0045.8923

2 Answers   Ethio Telecom,


Categories