Answer / kumar

yes, protect from shocking

Application wise, where we should use AC motors and where we should DC motors?

1 Answers   Nespak,

---

three owners X, Y, z owned some tractors with them, on the first month x gave away the same amount of tractors to y and z ( as much as they possed), similarly in the 2nd month y gave of to x and z similarly by third month z gave to x and y. after this all X, Y, Z had 24 tractors each.

2 Answers   econ,

---

Why usually in all electrical equipment taking more current in Y pahse like pumps,compressor,or any other applications

1 Answers  

---

what is ballast

1 Answers  

---

Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this

0 Answers   Ofer,

---

What is the Ideal Earth to Neutral Rating for Techonology Equipment like Routers, Switched, PABX, Computers etc etc?

2 Answers  

---

why excitor coil of an alternator can fail

3 Answers  

---

During the troubleshooting of an inoperative shunt generator, you found the voltage to be 2+ volts; what is known from this. Is it (1). odds are the armature is good (2). odds are there is no field current flowing in field windings (3). odds are the armature is bad (4). both 1 & 2 are correct (5). both 2 & 3 are correct

2 Answers   Air Force,

---

full form of flry b

0 Answers   KPIT,

---

what happens when one of the phases out 0f 3 phases been removed under working condition and no load condition will the machine run if so plz send me why

2 Answers  

---

What is The function of tvm(tri-vector meter)??

2 Answers  

---

Difference between induction motor and synchronous motor? i Think Synchronous motors operate at synchronous speed (RPM=120f/p) while induction motors operate at less than synchronous speed (RPM=120f/p – slip). Slip is nearly zero at zero load torque and increases as load torque increases am a right pls guide & send Other Comments

5 Answers   Jindal,

---