Interested to Buy Any Domain ? << Click Here >> for more details...
Which layer is responsible for routing through an internetwork?
A.) Physical
B.) Session
C.) Network
D.) Transport
E.) Application
F.) Data Link
- 1 Answers
- 7142 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: C
The Network layer is responsible for routing. This is the
primary job of
routers, which operate at the Network layer.
| Is This Answer Correct ? | 16 Yes | 0 No |
What ISDN protocol specifies concepts, terminology, and services? A.) Q B.) S C.) I D.) E
Explain what are partial updates?
What is size of ipv4 mac address?
What is difference between routing and routed protocols?
How do you configure a Cisco router to route IPX?
hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
Which of the following protocols are used to get an IP address from a known MAC address? A.) BootP B.) TCP C.) IP D.) ARP E.) RARP F.) ICMP
What is the IP extended access list range? A.) 1000-1099 B.) 100-199 C.) 1-99 D.) 101-200
which defined peer ip address an local subnet belong to crete? (Choose two)
Which of the following provide connection-oriented transport to upper layer protocols? A.) SPX B.) RIP C.) NLSP D.) NCP
Which OSI layer end to end communication, segmentation and re-assembly? A.) Network B.) Transport C.) Physical D.) Application E.) Data-Link F.) Presentation
What are the protocol data units (pdu) in ccna?
CCNA 
