Interested to Buy Any Domain ? << Click Here >> for more details...
Identify 2 functions of IPX access-lists?
A.) Control SAP traffic
B.) Limit number of Novell servers on a network
C.) Limit number of workstations on a network
D.) Block IPX traffic
- 1 Answers
- 5417 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A D
IPX access lists are used to restrict IPX traffic and SAP
broadcasts.
| Is This Answer Correct ? | 5 Yes | 0 No |
Identify the access-list range for an extended IP access-list? A.) 800 - 899 B.) 1 - 99 C.) 1000 - 1099 D.) 100 - 199
What is the total bandwidth of all channels on a BRI circuit? A. 56 kps B. 64 kps C. 112 kps D. 128 kps E. 144. kps
What is subnetting and supernetting and its uses?
Cisco routers use wildcard masking to identify how to check or ignore corresponding IP address bits. What does setting a wildcard mask bit to 0 cause the router to do? A. It tells the router to check the corresponding bit value. B. It tells the router to ignore the corresponding bit value. C. It tells the router to check its alternate routing list. D. It tells the router to use its primary routing list.
Which layer hides details of network dependent information from the higher layers by providing transparent data transfer? A.) Transport B.) Physical C.) Data Link D.) Session E.) Application F.) Network
What is the extended IPX access list range? A.) 901-1000 B.) 100-199 C.) 900-999 D.) 1000-1000
What is the function of the Transport layer and which protocols reside there? A.) MAC addressing - IP B.) Interhost communication - SQL, NFS C.) Best effort Packet delivery - TCP, UDP D.) End-to-end connections - TCP, UDP
what is route aggregation
What command do we give if router ios is stucked?
Define Poison Reverse? A.) To prevent regular update messages from reinstating a route that has gone down B.) Packets sent out that are not destined for a network go to the default network C.) Information received on an interface cannot be sent back out the same interface D.) When a network goes down, the router enters in its table the number 16 to signify destination unreachable
Identify the command that disables name-to-address translation? A.) Router(config-dns)# no ip domain-lookup B.) Router(config)# no address translation C.) Router(config)# no ip domain-lookup D.) Router(config)# ip domain-lookup
What is the difference between csma/cd and csma/ca?
CCNA 
