Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the OSI layer associated with bits?
A.) Physical
B.) Network
C.) Binary
D.) Data link
- 2 Answers
- 6236 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: A
The Physical layer converts the frames to bits.
| Is This Answer Correct ? | 4 Yes | 0 No |
What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot
Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecing to non-Cisco equipment C.) You must use Q.933a encapsulation if connecing to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment
which layer is responsible for flow control with sliding windows and reliability with sequence number and acknowledgement? A)Transport. B)Application C) Internet D)Network Interface
bWhich form of PPP error detection on Cisco routers monitors data dropped on a link? A. Quality B. Magic Number C. Error Monitor D. Droplink
Explain how many tables are in ospf protocol?
ip dhcp excluded-address 192.168.0.1 192.168.0.19 what is the use of that command can any one explain it
Identify the correct IGRP configuration? A.) Router# router igrp 100 Router# network 10.0.0.0 B.) Router(config)#router igrp 100 Router(config-router)#network 10.0.0.0 C.) Router(config)# router igrp Router(config-router)# network 10.0.0.0
Suppose a Switch interface went in error-dis mode what you will do for Troubleshooting List all Possibilities
What does a metric of 16 hops represent when using RIP? A.) Number of hops to the destination B.) Destination unreachable C.) Number of routers D.) Bandwidth
What is ping? What is the usage of ping?
Which of the following is a connectionless protocol at the Transport layer? A.) UDP B.) ARP C.) ICMP D.) RARP E.) IP F.) FTP
what command you must use if you want to delete or remove the configuration data that is stored in the NVRAM?
CCNA 
