Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the correct IGRP configuration?
A.) Router# router igrp 100
Router# network 10.0.0.0
B.) Router(config)#router igrp 100
Router(config-router)#network 10.0.0.0
C.) Router(config)# router igrp
Router(config-router)# network 10.0.0.0
- 3 Answers
- 6486 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / abhay kumar
router(config)#router igrp 100
router(config-router)#net 192.168.0.0
crtl+z
| Is This Answer Correct ? | 5 Yes | 0 No |
Identify the keystroke to position the cursor to the beginning of a command line? A.) Ctrl-A B.) Ctrl-Ins C.) Ctrl-B D.) Ctrl-Z
what is the difference between dynamic NAT and NAT overload ? and how it works ?
Assume that you are editing a line of text on a Cisco router. What key-stroke combination would take you to the beginning of the line? A.) CTRL-B B.) CTRL-Z C.) CTRL- D.) CTRL-A E.) CTRL- F.) CTRL-
When dr communicate with bdr which multicast ip it use?
Which ipsec rule is used for the olympia branch and what does it define? (Choose two)
Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP
Tell me which cable called roll-over?
Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction
The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independence and what else? A.) Provides Windowing. B.) Provides flow control. C.) Provides SAP's (Service Access Points). D.) The Datalink layer does not have sublayers. E.) Provides SAP's (Service Advertising Protocol). F.) RIP Updates.
Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface
Which service uses telephone control messages and signals between the transfer points along the way to the called destination? A. Signaling System 7 (SS7) B. Time-division Multiplexing (TDM) C. X.25 D. Frame relay
Which IP address and wildcard mask would you use in your ACL to block all the hosts in the subnet 192.168.16.43/28?
CCNA 
