Answer / guest

Answer:: A

The Quality protocol monitors data dropped on a link. Magic
Number

avoids frame looping.

When a Distance Vector routing protocol detects that a connected network has gone down, it sends out a special routing update packet, telling all directly connected routers that the distance to the dead network is infinity. This is an example of which routing technology? A.) ICMP. B.) Only Link State routing protocols have this intelligence. C.) Triggered updates. D.) Garrison-4. E.) Split Horizon. F.) Poison Reverse.

1 Answers  

---

The two sublayers of the IEEE Data Link Layer are which of the following? A.) Link and Logical Control B.) Data Link and LLC C.) Logical Link Control and Media Access Control D.) Data Link and MAC

2 Answers  

---

What are packets?

0 Answers  

---

Select the most correct statement regarding client port address assignment. The client port always matches the destination port. To access a web page the client uses the source port of 80 and the destination port is dynamically selected. When a client requests a web page the destination port is 80 by default and the source port for the client is dynamically selected. The client source port is 1024 to get web pages and 1055 when retrieving ftp files.

2 Answers  

---

Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename

2 Answers   HSBC,

---

When setting up a WAN network, everything outside of the Demarc is not owned by the customer. Which of the following are not owned by the customer? A.) The T1 line. B.) LAN C.) The Router D.) DTE E.) PC's F.) CO

1 Answers  

---

Which of the following provide connection-oriented transport to upper layer protocols? A.) SPX B.) RIP C.) NLSP D.) NCP

1 Answers  

---

What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.

3 Answers  

---

Hi- Salmaan my name is Shadab Khan and nick Khangkp ok salmaam plz tell me about of NAT plz

3 Answers  

---

Identify the definition of demarcation? A.) Date in which the WAN service contract expires B.) Cabling which extends from the WAN service provider to the customer C.) Division of responsibility, where the CPE ends and the local loop begins D.) Equipment which is located at the customer premises

2 Answers  

---

Define network?

0 Answers  

---

What is the role of the LLC sublayer?

0 Answers  

---