Hi
I asking one thing that my company having cisco ip phone
with connected to cisco poe switch.But sometime when my
agent calling to customer on that time customer voice is
break only few 2 to 3 sec.I have already checked my wan link
by isp and also lan connection,but this problem is not
sorted out so pls help me.
- 5 Answers
- 5985 Views
- Infotech, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / jitenedera kuamr sinha
have you conected yours ip phone to gigabyte port of the
switch or it is simply coeted wirth the fastethernet port?
Please check it out and let me know then only i can make
some suggestions
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / dharmedra
Hello jitendra ji,
My company all are ports connected to fa0/0 ethernet port
with cisco sw : 3550,3750.
Thanks
D.soni
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / jitendra
ok the connect sfe gigabyte mofule to your switch and then
conect the ip phone dirctly to that
this might be solved the issue
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / dharmendra kumar soni
How This is possible bcz my company having multiple cisco
phone these all are connected with patch panel on switch in
that case we can,t anything and switches are located on
server room so how to possible that...........
please give provide any way by which i can able to do this
..........
Thanks
D.soni
| Is This Answer Correct ? | 0 Yes | 0 No |
What is the multicast routing?
What information is provided by the local management interface (LMI)? A.) LMI encapsulation type B.) The current DLCI values C.) The status of virtual circuits D.) The global or local significance of the DLCI values
Can anyone explain in details the STP port state?????
Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share
Which of the following will show an extended access list 150? A.) sh access-list 150 B.) sh ip int C.) sh ip access-list D.) sh access-list 150 extended
which is following route will be used to froword data in a situation where a routing table tables contains static ,RIP,IGRP routes destined to the same network with each set to its default administrative distance
Identify the command to configure the IP address 172.16.100.5 255.255.255.0? A.) Router(config-if)# ip address 172.16.100.5 255.255.255.0 B.) Router(config)# ip address 172.16.100.5 C.) Router# ip address 172.16.100.5 255.255.255.0 D.) Router(config)# ip address 172.16.100.5 255.255.255.0
What is Data, management, native, default,trunk and access vlan?
What is ccna?
In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to PAVRAM before becoming enabled
What are the things that can be accessed in a CISCO router’s identifying information?
What do you understand by poe (power over ethernet)?
CCNA 
