Interested to Buy Any Domain ? << Click Here >> for more details...
Which command would show all Ethernet interfaces with IPX
configured on them?
A.) show interface ipx ethernet
B.) show ipx interface
C.) show ipx interface ethernet
D.) show ipx
E.) show version
F.) show run
- 1 Answers
- 4171 Views
- I also Faced
- E-Mail Answers
Which IP address and wildcard mask would you use in your ACL to block all the hosts in the subnet 192.168.16.43/28?
Which commands should you use to enable IGRP routing? A. router igrp 100 Network 192.168.1.0 Network 10.0.0.0 B. router igrp 100 Network 192.168.2.0 Network 10.0.0.0 C. router igrp 100 Network 192.168.1.0 192 168.1.1 Network 10.2.0.0 10.2.1.1 D. router igrp 100 Network 192.168.1.0 255.255.255.0 Network 10.2.0.0 255.255.255.0
Explain the types of ospf configuration?
which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..
Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction
thnx Jitender singh...as u told to install a stp in switches and problem vil b get solved...i wanna kno how to install stp in switches?? plz tel me detailled steps... thanx for ur answer.
In regards to the ISDN BRI standard, which channel is used for control? A.) B B.) D C.) E D.) I E.) Q
Which protocol will send a message to routers if a network outage or congestion occurs? A.) ARP B.) TCP C.) IP D.) ICMP
What are characteristics of UDP A. It is reliable and acknowledged B. It is unreliable and acknowledged C. It is reliable and unacknowledged D. It is unreliable and unacknowledged
What does vlan provide?
Of the following switching types, which one has the highest latency? A.) Cut-through B.) None C.) Store-and-forward D.) Fragment Free
hi friends i am jitendera kumar sinha.i have a question in mind that what is the diffrence between router and l3 switch i serched on google and found that switch L3 is best in lan and router are best in wan and switch are more faster then router.beside that any short of technical diffrence if you body know then plz plz and plz reply. my 2nd question is that why we canot replace router with L3 switches (donot tell that it is costly then router).i want any technical cause. this is 1 am hope in noon when ever i logg again i will find the answer posted by you. thanks onse again plz pzl make reply thanks jitendera kumar sinha jitenerasinha.it@gmail.com
CCNA 
