Name a major component of the Point-to-Point Protocol (PPP) to negotiate and set up control options on the WAN data link. A.) RFC 1661 B.) High Level Datalink Protocol (HDLC) C.) Challenge Handshake Authentication Protocol (CHAP) D.) SS7 E.) Link Control Protocol (LCP)

2 Answers  

---

Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  

---

How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds

2 Answers  

---

What is the difference between half duplex and full duplex?

0 Answers  

---

Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verifies connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured

1 Answers  

---

Identify the keystroke to position the cursor to the beginning of a command line? A.) Ctrl-A B.) Ctrl-Ins C.) Ctrl-B D.) Ctrl-Z

2 Answers  

---

What is 10baset ethernet lans?

0 Answers  

---

Explain the types of ospf configuration?

0 Answers  

---

Identify the command to display the status of the Frame Relay virtual circuit? A.) Router# show frame-relay virtual-circuit B.) Router(config)# show frame-relay pvc C.) Router# show frame-relay pvc D.) Router# show virtual

1 Answers  

---

What is the protocol number for UDP? A.) 6 B.) 17 C.) 25 D.) 21

1 Answers  

---

The maximum distance on a 10BaseT network from the hub to a workstation is which of the following? A.) 500 meters B.) 1000 meters C.) 100 meters D.) 1500 meters

1 Answers  

---

On which mode we give debug command?

0 Answers  

---