Answer / guest

Answer: C, D

What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Gandalf5 B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) SAP

2 Answers  

---

What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1

3 Answers   Cisco,

---

Which of the following are Session Layer standards? A.) ASCII and EBCDIC B.) MPEG and MIDI C.) NFS and SQL D.) JPEG and PICT

2 Answers  

---

Define ios?

0 Answers  

---

Of the following, which reason applies to dividing a large network into two or more smaller networks? Performance Security Address Management All of the above

2 Answers  

---

What is the difference between csma/ca?

0 Answers  

---

Which layer defines bit synchronization? A.) Application B.) Network C.) Transport D.) Physical E.) Session F.) Session

1 Answers   Rooman,

---

What not a name of an ISP? A. MSN B. Comcast C. Verizon D. McDonalds

2 Answers  

---

What does the parameter -- LOG -- do on an IPX access list? A.) The log keyword is not a valid option. B.) Read the LOG to figure out what traffic to deny. C.) Logs the creation of the access list. D.) Logs IPX access control list violations whenever a packet matches a particular access list entry. E.) Ensures the IPX protocol places a log in the fireplace.

1 Answers  

---

What is the routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) TTL D.) Hop count

1 Answers  

---

The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full

1 Answers  

---

What is a protocol

13 Answers   Network, TATA,

---