Which IP Address Class can have 16 million subnets but

support 254 hosts?

A. Class C

B. Class A

C. Class B

D. Class D

Answers were Sorted based on User's Feedback



Which IP Address Class can have 16 million subnets but support 254 hosts? A. Class C B. Cla..

Answer / m haja bahurudeen

Ans : A

Class A
Subnet : 254 host : 16 million

Class B
Subnet : 65554 host : 65554

Class C
Subnet : 16 million host : 254

Is This Answer Correct ?    6 Yes 2 No

Which IP Address Class can have 16 million subnets but support 254 hosts? A. Class C B. Cla..

Answer / guest

Answer: A

Possible Subnets IP Address Class Possible Hosts

254 A 16M.

64K B 64K

16M C 254

Is This Answer Correct ?    5 Yes 2 No

Which IP Address Class can have 16 million subnets but support 254 hosts? A. Class C B. Cla..

Answer / upendr kushwaha

B. Class A

Is This Answer Correct ?    4 Yes 2 No

Post New Answer

More CCNA Interview Questions

What are the different types of cables that are used in routing?

0 Answers  


What is the default behavior of access-list?

0 Answers  


The network portion of an address typically represents a: A.) Router B.) Ethernet MAC address. C.) Computer D.) Host E.) Segment

3 Answers  


If you have configured IPX on a Serial interface, which command would display the IPX network and node address on the Serial 1 interface? A.) show interface B.) show ipx s1 C.) show interface s1 D.) show ipx int serial 1 E.) show ipx int brief

1 Answers  


The following is partial output from a routing table ; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' Which routing protocol is being used? (assuming defaults have not been changed) A.) OSPF B.) RIP C.) BGP D.) IGRP

1 Answers  






What is the difference between full duplex and half duplex?

0 Answers  


Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP

3 Answers  


Why ESP Transport mode is not compatible with NAT????? Though New IP Header in Tunnel mode & Original IP Header in Transport mode are out of Authentication & Encryption.

1 Answers  


What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a

3 Answers  


Which statement is true regarding Administrative distance? A.) It is a metric B.) Number of hops between two routers C.) Trustworthiness of the routing information D.) RIP Administrative distance is 100

1 Answers  


What are the different ways authentication mechanism in VPN?

0 Answers   CCIE,


A user device that connects to a DCE must be which of the following? A.) DTE B.) CPE C.) Demarc D.) DCE E.) CO

1 Answers  


Categories