Explain the difference between routing and routed protocols?

0 Answers  

---

What device has content-addressable memory (CAM) and what is stored in it? 1 A: Switch, learned IP addresses 2 B: Router, learned IP addresses 3 C: Switch, learned MAC addresses 4 D: Router, learned MAC addresses

4 Answers  

---

How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets

1 Answers  

---

Can 2 different VTP Domain Communicate. if yes then How.

7 Answers  

---

When you enter router passwords during the setup dialog what is the difference between enable and the enable secret passwords? A. The enable password is encrypted B. The enable secret password uses IPSec password authentication C. The enable secret password cannot be seen as clear text when viewing the configuration D. The enable secret password acts as a backup in case the enable password is compromised

8 Answers   Wipro,

---

---

Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25

1 Answers  

---

What is difference between standard and extended access-list

17 Answers   College School Exams Tests, HCL, Wipro,

---

Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102

2 Answers  

---

Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp

1 Answers  

---

Explain what is route poisoning?

0 Answers  

---

Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make fowarding decision using MAC address E.) Create collision domains

1 Answers  

---

Which ISDN protocol prefix specifies switching and signaling? A.) I B.) E C.) Q D.) S

1 Answers  

---