differences b/w two stroke engine and four stroke engine?

Categories >> Engineering >> Mechanical Engineering
Suggest New Category

Question Posted / raghuegold

5 Answers
8107 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

differences b/w two stroke engine and four stroke engine?..

Answer / chandan kumar

In two stroke engine the cycle is comlted in one revolution
of crank where in four stroke engine the cycle is
compeleted in two compelete revolutionss of crank.

Is This Answer Correct ?

33 Yes

2 No

differences b/w two stroke engine and four stroke engine?..

Answer / nasrath ali

1)In 2t engines there wil be one idle stroke nd 1 power
stroke
Bt in 4t engines der wil be 3 idle strokes nd 1 power
strokes
2)In 2t engines, der wil b ports whereas in 4t engines der
wil b valves

Is This Answer Correct ?

7 Yes

1 No

differences b/w two stroke engine and four stroke engine?..

Answer / ajay karthik

compression ratio differs frm each other

Is This Answer Correct ?

7 Yes

4 No

differences b/w two stroke engine and four stroke engine?..

Answer / h.m.farhan

in 4 strok engien piston move Top Ded Center to Botem Ded
Center. in 4 strok engin use are valve intow strok engien
same mater but not use in valve in this engien

Is This Answer Correct ?

3 Yes

0 No

differences b/w two stroke engine and four stroke engine?..

Answer / renjith pillai

apart from the main differences stated above,
two stroke engines produce high torque than 4s, as it got
one power stoke at every 2 strokes.
the amount of lub oil and cooling water consumption will be
higher in 2-s engines due to the abov reason.
the 2s engines do not hav more complicated valve mechanisms
as in 4s engines.

Is This Answer Correct ?

3 Yes

2 No

Post New Answer

More Mechanical Engineering Interview Questions

Why is Air Conditioner capacity measured in ton like 1.5ton?

3 Answers

what is the regulating speed in a hydraulic coupling

1 Answers

How a main gate (steel) get support from top whlie slides on the rail fixed on the bottom surface??

0 Answers

if C.R increases then detonation will increase or decrease

4 Answers

As per api 650 code for new ss tank fabrication,in bottom plate bulge is acceptable? How many bulge acceptable for api 650?

0 Answers Hyundai,

what's the diffrent between k engine series and qsk engine series and specialey fuel system

0 Answers Cummins,

what's the difference between moment of inertia and mass moment of inertia?

4 Answers

If Seller is Registered with Karnatka State and Selling the Engg. goods to Delhi based non registered company, then what is the CST they charge?

0 Answers

How will you create a piston head?

0 Answers

What is shearing?

0 Answers

How much pressure on air reservoir?

2 Answers

what is the rpm of Turbocharger of Cummins KTA50G3 Diesel Engine?/ Normally What is the rpm of Turbocharger for any 1 MW Engine?

0 Answers HMT,

For more Mechanical Engineering Interview Questions Click Here