What is A Check, B Check, C Check & D Check for Diesel
Generators?
Answer / amit kumar
A-Check (Daily routein Check)
1. Check oil level.
2. Check cleanliness of DG
3. Check Battery Voltage
4. Check any Leakage
5. Check all filter condition
6. Check oil Level
7. Check coolent Level
8. Check Check V-Belt condition
B-Check (Every 300- 350 Hrs.)
1. Change oil.
2. Change oil filter,fuel filter,bypass filter.
3. Change Air Filter.
4. Change water Separator
5. Radiator cleaning with chamical
C-Check (Every 800-1500 Hrs.)
1. Change oil.
2. Change oil filter,fuel filter,bypass filter.
3. Change Air Filter.
4. Change water Separator
5. Radiator cleaning with chamical
6. Check All Electrical terminal & thimbles
7. Check polution level
D-check (Every 3000- 5000 Hrs.)
1. Complete DG set should be dismental.
2. Turbo charger service
3. Injector Pin service
4. Cylinder Head service
5. PT Pump sevice &
6. Repeat same B-Check process.
If your DG set running hours more than 10,000 then in D-
Check You should need to be
1. Change Piston Bearing,
2. Change nozels,
3. Piston Cylinder also need to be change.
4. Change Canopy filter if require
5. Check polution level
Is This Answer Correct ? | 0 Yes | 0 No |
Where is the maximum temperature in refrigeration cycle? a.Between evaporator & compressor. b.At Compressor c.Between compressor and condensor. d.At condensor
Define tons of refrigeration and cop.
HOW I SHOULD CALCULATE HEAT LOUD
what will be the min curvature ratio for Round Bar dia. 1” size in material grade AISI 4330, Yield strength 115KSI Tensile 140KSI?
Hi.. I am studying Mechanical Engineering.. And I am going to prepare for an interwiew of Caritor a software company.. so pleaz tell what i want to study in software and how I should prepare???
which type feect in generator and turbine in reverse power protection
RRB exam model questions pls forward.
What is the purpose of bilge separator
can any1 provide me the PLACEMENT PAPERS FOR BHEL
Explain how the cylinder lubrication on main engine is done?
Sketch the jacket cooling system?
Which tools are used in fitting shop?