Answer / sindhejs

We know that Power out=Torque*speed in rps.
Since in DOL condition there is no speed changing means no
change in power out,while in VFD there will be speed
changing using the frequency control,so the power out
changes from power input in VFD(Assuming that torque is
constant).

WHAT IS EXTENDED DELTA AUTOTRANSFORMER? WHERE WE USE THAT?

2 Answers   Amtek, TATA,

---

why we are using KVA rating for transformer,not KWh rating?

5 Answers   NTS,

---

Is it necessary to seperate the DG earth grid with Electricity Board earth grid for protecting the DG set. if yes why?

2 Answers   BARC,

---

1.What is the difference between isolators and circuitbreakers? 2.What is bus-bar?

1 Answers  

---

what is power system.........?

1 Answers  

---

If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?

0 Answers  

---

how to calculate neutral current in three phase four wire system

1 Answers   Auto Meters,

---

what is residuel magnetism. and how order lead acid batteries for 24 volt. emergency lighting system.

0 Answers  

---

The undesirable property of an electrical insulating material is

3 Answers  

---

What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?

0 Answers   Hira Group,

---

why we are using large cross section cable at load side and small at other (11kv to trsfr)side of transformer? when the load increses current at both side increases,right?

2 Answers  

---

What determines the thermal loading on the motor?

0 Answers  

---