If the positive terminal of batteries in 125 v dc system is
connected to earth what will happen ?
Answers were Sorted based on User's Feedback
Answer / stugger
hey nothing will happen, i dont know the technical reason
for this but i have tried for the 192 v dc battry sytem and
there is no shrt ckt.
| Is This Answer Correct ? | 6 Yes | 0 No |
Answer / sathish
This case is almost like a short circuit. Voltage almost becomes zero. And the current flowing becomes maximum
| Is This Answer Correct ? | 7 Yes | 3 No |
Answer / vinod
1) In ungrounded system nothing will hapend, earth leakage
information display in battery charger.
2) In -ve grounded system short circuit occur and
protection will operate with annunciation.
Normally ungrounded system is using with
leakage detector
| Is This Answer Correct ? | 4 Yes | 0 No |
Nothing wil happen, such system are adopted in
Telecommunication power supply since its inception and may
be for avoiding over voltage due to positive nature noise
added in the circuit. Always there will be less voltage
that (-) 125 Volt when any (+) volts noise is added.
| Is This Answer Correct ? | 1 Yes | 0 No |
Why we can not get 100% efficiency from a Gas Generator?
What is the high tension lines voltage and low tension lines voltage?33 kv is high tension line or low tension.
i have 90kw motor.so i choose connect cable .please what is parameter checked so please give to formula
How Calculet The UPS AH In Load
Why we use a shunt capacitor or synchronizing Motor To Improve a Power factor pls reply me in this mail dinesh_elect_eng@yahoo.com
what is d meaning of inrush current of a trafo ? how u can calculate this ?
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
0 Answers Eprosys Engineering Consultants,
please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in
what is the illumination level required for child play area?
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
Why Magnetic Core Balance test is performed only on Star side of Transformer and not on Delta Side of Transformer (Vector Group Dyn11)?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)