What is the maximum permissible Earth to Neutral voltage in
an electrical system.


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Chemical Engineering Interview Questions

how many TDS & TOTAL HARDNESS, PH of drinking water is recomanded for human being use.

4 Answers  


What are the design considerations for a piping system for the transfer of slurries?

0 Answers  


MASS TRANSFER - EXAMPLE 4.1 : A concentric, counter-current heat exchanger is used to cool lubricating oil. Water is used as the coolant. The mass flow rate of oil into the heat exchanger is 0.1 kg / s = FO. For oil, the inlet temperature TIO = 100 degree Celsius and the outlet temperature TOO = 55 degree Celsius. For water, the inlet temperature TIW = 35 degree Celsius and the outlet temperature TOW = 42 degree Celsius. What is the mass flow rate of water in kg / s, FW needed to maintain these operating conditions? Constant for heat capacity of oil is CO = 2131 J /(kg K) and for water is CW = 4178 J /(kg K). Use the equation (FO)(CO)(TIO ?TOO) = (FW)(CW)(TOW ?TIW).

1 Answers  


Question 37 - Calculate the bubble temperature T at P = 85-kPa for a binary liquid with x(1) = 0.4. The liquid solution is ideal. The saturation pressures are Psat(1) = exp [ 14.3 - 2945 / (T + 224) ], Psat(2) = exp [ 14.2 - 2943 / (T + 209) ] where T is in degree Celsius. Please take note that x(1) + x(2) = 1. Please take note that y(1) + y(2) = 1, y(1) = [ x(1) * Psat(1) ] / P, y(2) = [ x(2) * Psat(2) ] / P, * is multiplication. P is in kPa.

1 Answers  


Explain what is the method involved in analyzing powders for composition?

0 Answers  






what is AZ431 & how to check it by using multimeter?

0 Answers  


What can cause bulk solids to stop flowing from a bin?

1 Answers  


cetane no. and sulphur required in diesel fuel for euro-IV

2 Answers   IOCL,


Question 43 - In a non-dilute absorber, the inlet gas stream consists of 8 mol % carbon dioxide in nitrogen. By contact with room temperature water at atmospheric pressure, 65 % of the carbon dioxide from a gas stream has been removed. (a) Find the mole ratio of carbon dioxide and nitrogen gases at inlet and outlet gas streams. (b) The Henry’s Law provides y = 1640 x for carbon dioxide in water. Find the mole ratio when x = 0.0000427. Mole ratio is y / (1 - y) for y.

1 Answers  


PLZ ANYONE SEND ME PLACEMENT PAPERS OF I.O.C.L MY ID---- gaurav.nitw.5609@gmailcom

0 Answers   IOCL,


What are the steps taken to operate a tank-blanketing valve?

0 Answers  


Question 80 - Liquid octane has a density of 703 kilograms per cubic metre and molar mass of 114.23 grams per mole. Its specific heat capacity is 255.68 J / (mol K). (a) Find the energy in J needed to increase the temperature of 1 cubic metre of octane for 1 Kelvin. (b) At 20 degree Celsius, the solubility of liquid octane in water is 0.007 mg / L as stated in a handbook. For a mixture of 1 L of liquid octane and 1 L of water, prove by calculations that liquid octane is almost insoluble in water.

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16636)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)