how the ac voltage are selected like 220v,415v,750v,1000v&
1.KV,6.6KV,11KV,33KV,66KV,132KV,220KV & why these are
selected like these orders
Answers were Sorted based on User's Feedback
Answer / sathiyaraj.d
i dono the LT details.But HT the form factor 1.1 is the main
reson to calculate some electrical calculation
Is This Answer Correct ? | 17 Yes | 5 No |
Answer / rahul m. panchal
we r assuming thay the a.c current flow in sinusodial and it
is easy for us to calculated the r.m.s and average voltage so
due to form factor the r like this . as sin wave form factor is 1.1
Is This Answer Correct ? | 9 Yes | 4 No |
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
how much current will take for 1kw power. and what is the eqoutiion which is connecting with kw and A.
Why the output of OP-AMP is always less than Vcc?
What is the differance between negative dc voltage and positive dc voltage because some circuit uses -24,-5,-12,- 15,volt dc supply
10 Answers eLab, Hero Honda, NTPC, Suzlon, Teradyne,
Can VFD step up to 60 Hz if it is designed to receive 50 Hz input?
bus bar design conditions and sizing pls tell me quickly
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
why the value of k is more in shell typr transformers?
Difference between low impedance and high impedance Restricted Earth Fault
How to calculate CT ratio for 11KV 1500KVA Transformer 500KVA MD and 1400KVA connected load ? Note:- As per MSEB(Maharastra state electricity Board)
What is stray looses?
what is GRR(Grid Rotot resistance)?Why it is used beside of LRS?
9 Answers ACC, L&T, Sri Biotech,