Answer / bhagwan

From a layman's perspective.. Tube is a general term & pipe is a technical term. Tube can be anything even like a elect tube (Tube-light) or the underground-tube where the trains travel etc.. Pipe or 'Piping' is more related to application requirement & is regardless of ID/OD or length of the pipe.. hydraulic piping in M/c's or vehicles, Gas piping, water pipe's etc....

Answer / sudarshan

Depending on the applicable standard, pipe and tubing are
dissimilar in the sense that, a tube may have common wall
thickness irrespective of the pipe diameter for example a 2"
tube and a 3" tube would probably have a common wall
thickness of say 1.8mm whereas on the other hand a pipe,
will have varying wall thickness for different pipe
diameters( depending on its schedule, sch10, sch 40 etc ).
The varying wall thickness is such that the particular pipe
in question maintains its schedule rating irrespective of
the size. Tubes are not pressure rated and are generally
used in the food and beverage industry. Refer to Dairy
Tubing. Schedule Piping on the other hand is used primarily
in the process industry where particular pressure vessel
codes are applicable such as ASME B31.3

Answer / mehul dahod

Pipe is make
frome metals
and they are
not retain its
position after
band or
appliying
force.when tube
is made from
elasto matirial
(rubber) i
guss i am also
student of
mech.1 year

Answer / guest

the pipe are more diameter .as a compresion of tube

Answer / jhon

tube has very small dia compared to length

Answer / aditya tripathi

tubes are short in lenth pipe are large in lenth..

Give an example of a time when you had to explain some new procedures to your co-workers for quality service delivery. How did you go about it?

0 Answers   Ex-Solite Oilfield and Engineering, Schwing Stetter,

pl. send me jr.engg.model question for rrb malda.

0 Answers   RRB,

What are the causes of turbine vibration

0 Answers   RRB,

In order to ensure constant pressure and constant flow rate of compressed air what should we put between the compressure and end user?

0 Answers  

what is the required force to bend 2.5 MS sheet in 90 degrees and what is the formula to calculate the same?

0 Answers   Voltas,

Are you flexible working outside your country

2 Answers   Hotel Jobs, Marriott,

What Happens when oil pressure in a dg set come down to zero.What are the trouble shooting methods?

1 Answers  

What do you mean by cotter joint?

0 Answers  

What is the world's hardest metal?

0 Answers  

y we are used oil in the dead weight pressure tester

1 Answers  

what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.

0 Answers  

what is the purpose of bowl in a centrifugal purifier?

2 Answers   ACC,