Answer / manickavelu palanisamy

in semiconductor devices,whenever the voltage goes below the required voltage level the device will turn off. Because of the barrier in these devices and requires breakdown voltage.

Answer / amit thakur

when voltage is below than its required voltage then device
go its cut off state.every device work when its voltage is
grater then its cutin voltage.otherwise the device will be
in cutoff state.or its turnoff state

Answer / waseem

when voltages are below the range of requirement the
operation of the device normally affected but device could
not be turned off until completely voltage source is removed

Answer / raj

It barely depends on the load type
in resistive load the heating and lighting effect is reduced.

In Inductive type the magnetic field strength will be decreased

In capacitive load the voltage will be maintain due to surge voltage for define time period

But the first two type load the load may be burn due to drawn of the excessive current.

what is ip

6 Answers   Cisco, NSN,

---

Waht is DTX?

2 Answers   Nokia,

---

What do u mean by CODEC?

6 Answers   TCS,

---

WHICH TYPES OF QUESTION & WHICH BEST BOOK IN PREPARING FOR COMMUNICATION ?

0 Answers   BEL, GP,

---

How is sio2 layer formed in a monolithic ic?

0 Answers  

---

What are the causes of failure of mosfet in an high frequency application?

2 Answers  

---

A good op-amp has A Very high bandwidth B Narrow bandwidth C High selectivity D All of these

0 Answers  

---

Explain what is the difference between plc and dcs?

0 Answers  

---

how many ground terminal in 8086 microproccer?

3 Answers  

---

What is race around condition in a jk flipflop? How it can be avoided?

0 Answers  

---

What is the difference between latches and flip flop?

0 Answers  

---

what is the exact time required to set up a mobile to mobile call?

2 Answers  

---